Technical information
Liquid Spraying Methods
In order for any liquid to be sprayed, it must be dispersed with air or the liquid must be pressurized.
Read →
Spray Angle Chart
One of the most important technical data to consider when choosing a spray nozzle is the spray angle of the nozzle. The table below shows the impact area provided by the…
Read →
HVLP Spraying Technology
HVLP uses a high volume of air (typically between 15-22 CFM) delivered at low pressure (10 psi or less) to atomize paint into a soft, low-velocity spray pattern. As a…
Read →
Airmix Spraying Technology
• Airmix spraying technology, which consists of the combination of Conventional (Air) and Airless technologies, includes the advantages of both technologies.
Read →
How to Clean a Spray Gun?
Water should be used to clean water-based paints from the paint passing parts of the paint gun, and thinner should be applied to clean solvent-based paints. The holes of…
Read →
What are mold release oils used for?
These are oils used in pure form to remove the material from metal molds cleanly and easily, to prevent the material from sticking to the mold, and to prevent the mold…
Read →
What is Chemosil?
It is a special chemical that ensures the adhesion of rubber and metal during the vulcanization stage. A DERMIX JAGUAR PLUS model automatic spray gun is used to spray…
Read →
What is Postforming?
The most important feature of laminate material is that it can be shaped by heat transfer method. This is technically called postforming. DERMIX JAGUAR PLUS model…
Read →